Insert converter to the device programmer ZIF socket according
to the picture placed near of it. If you have some doubts about
orientation of this converter in device programmer ZIF socket, it is
valid general rule, the orientation of the text of title is the same as
the text on the top of the device programmer.
converter ClamShell ZIF socket. Insert the device into it (place device
on contacts). The right position of the programmed device in converter
ZIF socket is show at picture near (mainly left above) the converter
ZIF socket. On this picture reference corner (e.g. position of pin 1)
of device is indicated by dot, by number 1, by bezel or by any
combination of them.
Visually check interconnection between
device and converter ClamShell ZIF socket. If everything looks OK,
close it and now, device is ready for programming.
because the incorrect insertion of converter to the device programmer
ZIF socket or device to the converter ClamShell ZIF socket can damage
the programmed device.
To take out the device, open converter ClamShell ZIF socket and remove device from it.
When you finish work with converter, remove it from the device programmer ZIF socket.
not directly touch the pins of the converter and converter ZIF socket,
because dirt may cause errors during programming of device.
For handling with the device we recommended to use a vacuum pick up tool.